CUMMINS N14 Manuel d'installation télécharger pdf (Page 9)

3. Check master piston outside diameter ground surface

for nicks or burrs. Piston must slide in bore without

binding. Replace if binding occurs. Check top surface of

piston. Replace piston if there are cracks or pitting.

4. Clean all parts with approved solvent and lubricate

with engine oil.

5. Insert piston in bore. Piston must slide in bore without

binding. Replace if binding occurs.

6. Reassemble all parts in reverse order from

disassembly procedure.

Figure 5-11

7. Make sure spring tabs are aligned with raised surface

on end of piston.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

CUMMINS N14 Manuel d'installation Page 9