CUMMINS N14 Spécifications télécharger pdf (Page 359)

100

101

Install the oil pump body and the drive shaft assembly in

an arbor press.

Support the end of the drive shaft, and press the main

drive gear onto the shaft.

NOTE: At this stage of assembly, there must not be more

than 0.30 mm [0.012-inch] end clearance between the main

drive gear and the oil pump body. Use a dial indicator lo-

cated on the end of the lubricating oil pump drive shaft to

make this measurement.

Lubricate the inside diameter of the bushings in the driven

gear with clean 15W-40 oil.

Install the driven gear on the shaft.

Install the high oil pressure relief valve as follows:

1. Install locating plate, Part No. 3376013 (in DFC pres-

sure valve fixture, Part No. 3376011) on the oil pump

body.

NOTE: Use two 5/16 - 18 X 1 1/4-inch capscrews. Do not

tighten the capscrews at this time.

Install the large diameter of valve mandrel, Part No.

3376012, through the locating plate into the pressure limit

valve bore in the oil pump body.

Tighten the capscrews, and remove the mandrel.

Lubricating Oil System Lubricating Oil Pump - Rebuild (07-06)

N14 Page 7-17

1 2 ... 354 355 356 357 358 359 360 361 362 363 364 ... 586 587

Commentaires sur ces manuels

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Spécifications Page 359

Commentaires sur ces manuels